Stenter Replaces The Cutter Head In Time


When Stenter is used for three months, the carbon brush in the dust collecting motor should be checked in time.

.

As a professional Flat Screen Printing Machine manufacturer, Licheng Printing and Dyeing Equipment Co., Ltd. will explain some maintenance methods for Flat Screen Printing Machine:

  1. The blade of the Flat Screen Printing Machine is removed every day to clean the dust and thread inside the cutter head and the air duct. (Note: After installing the blade, the blade tooth tip should be about 1mm lower than the windshield and not higher than the windshield, so as to avoid the blade tooth tip will damage the workpiece fabric)
  2. Regularly check whether the trash bin is full 2/3, and clean it in time if it is full.
  3. Check whether there is oil in the oil bottle, if not full, and check whether the cutter head has oil supply.
  4. When Stenter is used for three months, the carbon brush in the dust collecting motor should be checked in time. If it is shorter than 6mm, it should be replaced in time.
60 Просмотры